Blow and Go Holster for Low Cost
This mounting unit is compatible with Low Cost ignition interlock devices and all other blow and go’s that have a knob on the back of the unit.
Mount it to your center console, and it will harness the cord and the interlock in one small device.
For use with ignition interlocks with the below knob mounted on the back of the device.
Self Tapping Screws
This is the most secure mounting option for mounting the Low Cost ignition interlock device onto the center console. It will leave two small holes on the dash once the mounting unit is removed. Use the included self-tapping screws to mount the unit (rectangular side with hooks) in the desired position in your vehicle where you want the ignition interlock to sit. It’s helpful to sit in the vehicle and position the Low Cost device and holster to ensure comfortability before mounting. A medium sized Philips screw driver is required. There are two screw holes partially drilled which will serve as a guide for the self tapping screws.
The unit also includes a Velcro adhesive option for mounting the Low Cost Device. Dash boards are made to be stain and stick proof, and mounting the holster using adhesive is not as effective as using screws. It will minimize any lasting marks on the dash, but using the screws is the safest option.
- Ensure the area where the holster will be mounted is free from debris or dash cleaning/protectant products (ArmorAll, Turtle Wax). These products will prevent the Blow and Go Holster from adhering to the dash effectively. Thoroughly clean the area where the holster will be placed with water and towel, and let dry completely.
- Remove the adhesive backing from the Blow and Go Holster (rectangular side) and stick onto the desired position. Hold firmly for 30 seconds. The adhesive will be ineffective if peeled off and placed back on again.
- After mounting the holster, it is important to wait 24 hours for the adhesive to set before using it. When attaching the interlock cord to the hooks, make sure there’s as little tension as possible pulling on the holster while ensuring there’s enough slack to pull the interlock device to your mouth.
- The adhesive can be removed by gently scrapping/scrubbing the adhesive from the dash. Goo Gone and alcohol-based cleaning products also work well.
*The Low Cost ignition interlock device in the photos is used for holster demonstration purposes only and is NOT included with the Blow & Go Holster.
**This product includes 1 x Blow & Go Holster unit, 1 x Adhesive Velcro Set, 1 x Set of self tapping screws.